SMW 5

titel-smw-5.jpg
titel-smw-5.jpg
oberflaechenschliff-produkt.jpg
titel-smw-5.jpg
oberflaechenschliff-produkt.jpg
SMW 543
LISSMAC Grinding Machines of the SMW 5 series set benchmarks for perfect surface finish using the wet grinding process. The SMW 5 is built according to the modular principle and can be individually configured to meet customer requirements and is characterised by low tool costs, simple handling and also by the cost effective price-performance ratio which results in short amortisation times.

Description

  • Surface machining or deburring of workpieces up to 120 mm sheet metal thickness
  • Freely configurable – individually customised to the customer's requirement
  • High quality surface finish up to fine grinding
  • Simultaneous deburring of interior and exterior contours
  • Wet machining
  • Simple, intuitive operation
  • The processing units can be individually adjusted or turned on and off electrically.
  • Maximum productivity while maintaining machining quality
  • Faster and simpler tool change within just a few minutes
  • Modular and compact in modern machine design - smaller footprint
  • Improved work environment - Reduction of dust, dirt and noise
  • Optionally available: Conveyor Technology, Filter Technology; Handling Systems, Automation; Custom Solutions
  • Especially suitable for the material mix
  • Entire process lines – Grinding and Part Cleaning

Technical data

SMW 5

No. Of heads 1 – 4
Compressed air 6.0 bar
Abrasive belt length 1900 mm
Capacity of the coolant 400-600 l
Working width 950 / 1350 / 1650 mm

SMW 5 USA

No. Of heads 1 – 4
Compressed air 6.0 bar (87 psi)
Abrasive belt length 1900 mm (75 inch)
Capacity of the coolant 400-600 l (105.8-158.3 gal)
Working width 950 / 1350 / 1650 mm
(37 / 53 / 65 inch)

Downloads

Overview Products

  • These products could also be of interest